IEC 60384-18-1:2007 pdf download – Fixed capacitors for use in electronic equipment – Part 18-1: Blank detail specification – Fixed aluminium electrolytic surface mount capacitors with solid (MnO 2 ) electrolyte – Assessment level EZ
1 General data
1 .1 Recommended method(s) of mounting (to be inserted)
(See 1 .4.2 and 4.3 of IEC 60384-1 8).
1.2 Dimensions
1.3 Ratings and characteristics
Rated capacitance range (see Table 2)
Tolerance on rated capacitance
Rated voltage (see Table 2)
Category voltage (if applicable) (see Table 2)
Climatic category
Rated temperature
Rated ripple current (see Table 3)
Tangent of loss angle (see Table 3)
Leakage current
Impedance (if applicable) (see Table 3)
Reverse voltage (if required)
Insulation resistance (if applicable)
1.4 Normative references
The following referenced documents are indispensable for the application of this document.
For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60384-1 , Fixed capacitors for use in electronic equipment – Part 1: Generic specification IEC 60384-1 8:2007, Fixed capacitors for use in electronic equipment – Part 18: Sectional
specification – Fixed aluminium electrolytic surface mount capacitors with solid (MnO 2 ) and non-solid electrolyte
IEC 6041 0:1 973, Sampling plans and procedures for inspection by attributes
1 .5 Marking
The marking of the capacitor, if applied, and the package shall be in accordance with the requirements of 1 .6 of IEC 60384-1 8.
NOTE? The details of the marking of the component and package should be given in full in the detail specification.
1.6 Ordering information
Orders for capacitors covered by this specification shall contain, in clear or in coded form, the following minimum information:
a) rated capacitance;
b) tolerance on rated capacitance;
c) rated d.c. voltage;
d) number and issue reference of the detail specification and style reference;
e) packaging instructions.
1.7 Certified records of released lots
Required/not required.
1.8 Additional information (not for inspection purposes)
1.9 Additional or increased severities or requirements to those specified in the generic and/or sectional specification
NOTE Additions or increased requirements should be specified only when essential.
